Classic

Installation

The installation of the drier is extremely simple and can readily be carried out on a do-it-yourself basis, provided the necessary electrical points is available.

• The drier should be positioned on the wall at a height of approximately 1.22 metres (4 ft) measured from the base of the unit to the floor.
• Remove cover with the key provided. Mark and drill holes to the positions shown on the template provided, to suit wall plugs for No 12 x 2 1/2 " long screws and insert wall plugs.
• Make provision for electrical connection using supply cable suitable for 12 amps at 240 volts. A fused double pole isolating switch must be provided adjacent to the drier to permit complete isolation of the unit during servicing.

Servicing

The amount of servicing and maintenance required is minimal and consists of cleaning and inspection checks at six monthly intervals. The unit is backed by a 12 month guarantee and an efficient after sales spares service. Normally replacements or spares are available on a 24 hour turn round basis.

In pursuance of a policy of continued improvement, the manufacturers reserve the right to make alterations without notice.